![]() Neither question appears to be addressed. There's no sense in wasting time or energy on it. DPS did not provide any statistics, so I'm not sure the extent of the damage.Ĭonsidering I can purchase an new SATA II drive for $12 USD, I'm just going to replace it. Entering the BIOS, navigating to Storage and then Drive Protection System (DPS) Self-test resulted in DPS recommending replace the drive. I also like the GUI install, but I'm not married to it.ĭoes Debian 8 provide a choice to perform an fsck before installing the base system? If so, where is it? If not, then what is the process?ĭoes fsck have a setting to control how aggressively blocks are marked as bad? If so, what is it? If not, then what can be used?ĮDIT: the machine is an HP5850. The disk is large (about 500 GB) and a Debian 8 distro is relatively small (8-12 GB is usually more than enough), so I don't care if good blocks get marked as bad. After the filesystem is created but before the install occurs, I'd like an aggressive fsck performed to mark suspect blocks as bad. ![]() I'd like to try one last time to reload Linux before condemning the hard drive or machine. I performed a fresh install of the OS, but I'm still getting fsck complaints. It was so bad I could not run fsck and dispatch all the problems. We have frequent brown outs, and after the last one the disk was a mess. I have an old HP Athlon machine I use for testing software under the old processor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |